|
Author
|
|
carmine
CC Member
Registered: March 2004
Posts: 333
|
|
Comment Date: Fri May 10, 2013
|
|
Can we see more different angle shots
|
|
|
|
DMXF
CC Member
Registered: August 2007
Posts: 374
|
|
Comment Date: Fri May 10, 2013
|
|
Added image of intake port. Email me directly to pursue further
|
|
|
|
|
carmine
CC Member
Registered: March 2004
Posts: 333
|
|
Comment Date: Sat May 11, 2013
|
|
Are those bars in all the runners and
what is there purpose?
|
|
|
|
|
DMXF
CC Member
Registered: August 2007
Posts: 374
|
|
Comment Date: Sat May 11, 2013
|
|
Those are tubes the push rods go through. The TP avoided the bends and restrictions in the ports around the push rods by going right through them.
|
|
|
|
|
cobrarkc
CC Member
Registered: January 2004
Location: Wayne
Posts: 428
|
|
Comment Date: Mon May 20, 2013
|
|
Has this been run on an engine? Does it seal? Does it require valve cover modifications?
------------------------------
Cobrarich
|
|
|
|
|
DMXF
CC Member
Registered: August 2007
Posts: 374
|
|
Comment Date: Mon May 20, 2013
|
|
It has not been run, but the guy who did the work was pressure testing it as he was finishing the welding. It shouldn't require valve cover modifications.
|
|
|
|
|
cobrarkc
CC Member
Registered: January 2004
Location: Wayne
Posts: 428
|
|
Comment Date: Mon May 20, 2013
|
|
Has it been mounted on an engine and checked for squareness and correct angles? This looks to have been a major undertaking. I saw some pictures on another site and it has been changed dramatically. It looks like a stock valve covers lip will not clear where the plenums come up for the carbs.
http://buildandtune.com/?cat=11
------------------------------
Cobrarich
|
|
|
|
|
DMXF
CC Member
Registered: August 2007
Posts: 374
|
|
Comment Date: Mon May 20, 2013
|
|
Well, cobrarkc it sounds like no matter what anyone says you have your preconceptions. I'm not looking to sell it that bad to argue opinions; this is a high quality part that was prepped to go on a high dollar vintage works race engine, where a block and heads were supplied for mock up during the work. After all the effort, a set of the correct aluminum high riser heads were found and the TP parts were set aside. Hard core enthusiasts interested in working out a deal are welcome to email. Thanks
|
|
|
|
|
cobrarkc
CC Member
Registered: January 2004
Location: Wayne
Posts: 428
|
|
Comment Date: Thu May 23, 2013
|
|
I am just trying to get enough information about this manifold because you obviously are looking for good money. Don't you think that it is fair since this is not a mass produced product. I don't think anyone would buy something without find out as much as they could about it.
------------------------------
Cobrarich
|
|
|
|
|
