Help With Cobra Tail Light Wiring Needed

[Jim Coleman]

I am in process of installing a wiring harness in my Arntz.

The tail light assemblies are one piece units and only have 2 wires.

The wire colors are green with a white stripe and yellow with a white stripe.

Since there are 3 wires going to each tail light -- brake, turn signal & park -
how are they wired ?

Thanks,

Jim

[ALF]

Hi Jim
If you use the DB 10 relais and the Lucas L542 lights BREAK and TURN SIGNAL is the same wire.
- park light (5W on two wire bulp)
- break/turn signal (21W on two wire bulp)
- ground

[Jim Coleman]

Thanks, Alf-

Which wire is the brake lights/turn signal ?

Jim

[strictlypersonl]

Originally Posted by Jim Coleman

Thanks, Alf-

Which wire is the brake lights/turn signal ?

Jim

I wouldn't count on any consistency relating colors to filaments.

Turn the parking lights on and connect the live lead at the rear light to the wire of the dimmer filament.

[Jim Coleman]

What I did was install removable bullet connectors so I can change them around if needed after the harness is completely installed.

[ALF]

I've the 289 wire colors in use.
Red = RH/ LH Tail Lamp
White and Puple = LH Stop Lamp
White and Brown = RH Stop Lamp
Black = Ground

Originally Posted by Jim Coleman

Thanks, Alf-
Which wire is the brake lights/turn signal ?
Jim

[Jim Coleman]

Thanks, again Alf

Jim