New to the Coupe Forum

[951mat]

Hello all. I'm hoping some of you Superformance owners could be so kind to share some pics of your Daytona Coupe engine bracket set ups. I'm currently having a coupe built and would like to replicate similar bracketry (just AC and alternator). As you probably know there's not a lot of brackets out there that put the alternator on the driver side. Pics of the crank pulley would help as well if you have any.
I doubt its too dificult to fab up some of these brackets, but some pics would be helpful. I actually have a good one already for the AC bracket (Coupedup's album). I need the AC and the alt up high (~even with the heads) to go with the dry sump Any help would be appreciated. Once my build gets a little farther, I promise to start a build thread.

Mat

[redmt]

Look in Tony Ripepi's gallery for some pix

[951mat]

Come on, just one pic. I'll throwing a ride at run n gun in October.

Mat

[redchief]

Here is a photo of my Roush Engine before installing it into a SPF Daytona Coupe.

[951mat]

Thanks, that helps more. More to the brackets than I thought. Looks like I'll get to practice using my plasma cutter quite a bit to rough these pieces out.

More pics at more angles from others would still be appreciated.

Mat

[rcweingart]

I'm having trouble uploading my engine photos but I did my own install and have photos of my mounts and installation that I will send you in an email if reply with your e-mail address. Apparently all I can upload are photos that I've already uploaded. Ron Weingart