Need original Lockheed tie rod boots

[Robert Beede]

Folks, i need some NOS Lockheed rubber "dust cover boots" that keep the grease contained within the tie rods (the Brits call them ball joints, but that is a term Americans reserve for the lower joints of the uprights in rack and pinion cars). I have a worm and sector car using the Bishop gearbox and tie rods at the end of each link. Any help is much appreciated!

Thank you, Bob

[spdbrake]

Bob,

Morgans used Bishop and Lockheed parts. Just a guess though.
PN 100-602 on this page.
Morgan +4 Steering System Parts | Gemmer, Moto-lita, Bishop, Brooklands

Also it maybe easier to cannibalize a boot from an existing tie-rod end
lockheed in Vehicle Suspension and Steering Parts | eBay

Or go generic will-fit
https://www.balljointboots.co.uk/

[Robert Beede]

Great suggestions! Thank you for the time you spent searching on the web! I had not found those Lockheed parts on my E-Bay search, for unexplainable reasons.

I bought a cover from Morgan supplies a while back, but it was no where close to the original. I am trying hard not to bugger up my car with odd parts. These boots have been tough to source.

Most Appreciative!!
Bob

[rsk289]

Originally Posted by Robert Beede

...the Brits call them ball joints...

I call them 'track rod ends'.