Registered: November 2001 Location: Edmonton Posts: 465
Fri November 28, 2003 9:52pm
Rating: 10
I like the spark plug wires and cylinder head mounted brackets, could you give some info on them? Who makes them, part#'s and were to buy them? thanks. Rod
------------------------------ "This year Ferrari's Ass Is Mine"
Michael Quinn CC Member
Registered: July 2000 Location: Charlotte Posts: 12
Sat November 29, 2003 4:46am
The wonderful thing about this "hobby" is creativity. I actually custom made them out of metal that was around the shop. They are simple "L" shaped 1" wide stock with holes drilled in for zip tie retainers. I know it sounds hokie - but you can put a rubber insulator on before the wires and furher reduce cross fire possiblities. Plus it really keeps the wires off the headers! And they are not to bad to get to to remove the plugs.
Rodney CC Member
Registered: November 2001 Location: Edmonton Posts: 465
Sat November 29, 2003 9:20am
Cool, I might do the same. the wires are Moroso ultra 40 race? Thanks again.
------------------------------ "This year Ferrari's Ass Is Mine"
Michael Quinn CC Member
Registered: July 2000 Location: Charlotte Posts: 12
Sat November 29, 2003 2:24pm
8mm Moroso Blue Max 800 with a insulator sleeve by Moroso (also Blue Max product). The wires were custom cut for length - I used quality heat shrink on the ends over the sleeve. (of course I slid on wire/plug numbers to keep everything straight)
