Registered: April 1999 Location: cleveland Posts: 1,999
This is a mechanical fuel injection system made in the 1960's, hilborn style, constant flow - low pressure. It has 1 7/8" throttle bores, close to 48mm. This intake was also made with the throttle bores straight up, as opposed to at a 45 degree angle like this one. Probably a good start for an electrical fuel injection conversion. As there are no venturi's, it should flow better than 48IDA's, about 30% better.
· Date: Sat August 7, 2004 · Views: 1463 · Filesize: 80.8kb · Dimensions: 560 x 700 ·
Registered: March 2001 Location: E BRUNSWICK N.J. USA Posts: 3,841
Tue October 5, 2004 5:11pm
Rating: 10
Anthony Nice setup where did you find it? Take the tubes out and make it a cross ram so it fits under the hood. Dove built a croosram setup that way for dirt track. I am looking for one. Just talked to FFP, they didn't have one. Good luck with the conversion. Rick Lake
BigGuy Senior Club Cobra Member
Registered: December 2003 Location: Cleveland area, OH Posts: 25,033
Sun June 4, 2006 1:15pm
Rating: 10
------------------------------ Jon
-----------------
